Motorized CU Stage Example1 (1 axis and 1 controller) / CU020-ACT1D-GSC
A combination set that motorize the single-axis control of Core unit microscope sample stage at a low cost.
It can be used with Core unit microscope mini sample stage (CU-021) in the same configuration.
It can be used with Core unit microscope mini sample stage (CU-021) in the same configuration.
Contact us
Part Number
CU020-ACT1D-GSC
1) One of the manual stages (X-axis, Y-axis or Z-axis) of Core unit microscope can be motorized by introducing electric actuators and other devices.
2) Motorized control of the stage is available with the sample software SG Sample distributed on our website, and sample software for LabVIEW is also available. Click here for more information.
3) Even after the electric actuator is installed, manual operation of the stage is possible by pinching and turning the actuator tip when it is not being controlled electrically.
2) Motorized control of the stage is available with the sample software SG Sample distributed on our website, and sample software for LabVIEW is also available. Click here for more information.
3) Even after the electric actuator is installed, manual operation of the stage is possible by pinching and turning the actuator tip when it is not being controlled electrically.
| RoHS | No |
|---|---|
| CE | No |
| Guide | ▶Please contact our sales for consultation of the optical system using CoreUnit etc. |
| Attention | 1) This set shows an example of a combination of parts and other parts are required for use as a microscope. This product is shipped unassembled, and required to be assembled the parts and software by yourself. Please contact our sales for details on how to assemble them. The specifications of the set are subject to change without notice. 2) The compatible actuator is SGSP-13ACT-B0, and the same type of 25 mm actuator, SGSP-25ACT-B0 is not compatible. 3) Note that the dedicated tool MNS-12.5-14.5 and a ball-point type hexagonal wrench are required to install actuator. 4) The controller GSC-01 is dedicated to one axis. (Maximum number of divisions: 2) 5) The software provided is a sample program. If you need special control, you will need to develop the program yourself or ask us to custom order it for a fee. 6) The controller can be operated manually using the jog lever on the controller body. 7) The controllable travel range depends on SGSP-13ACT-B0 and is therefore up to 13mm. |
