Motorized CU Stage Example5 (3axis and feedback contorl) / CU020-RMH3D-RMC
3-axis control set of Core unit microscope sample stage.
The feedback control of the remote micrometer allows high-precision positioning.
The feedback control of the remote micrometer allows high-precision positioning.
Contact us
Part Number
CU020-RMH3D-RMC
1) One of the manual stages (X-axis, Y-axis and Z-axis) of Core unit microscope can be motorized by introducing electric actuators and other devices.
2) Motorized control of the stage is available with the sample software SG Sample distributed on our website, and sample software for LabVIEW is also available. Click here for more information.
3) The feedback function of the RMH-13 allows for more accurate positioning than the SGSP-13ACT-B0, but the control speed is lower than the SGSP-13ACT-B0. Also, SGSP-13ACT-B0 allows manual operation when not electronically controlled, whereas RMH-13 does not allow manual operation.
2) Motorized control of the stage is available with the sample software SG Sample distributed on our website, and sample software for LabVIEW is also available. Click here for more information.
3) The feedback function of the RMH-13 allows for more accurate positioning than the SGSP-13ACT-B0, but the control speed is lower than the SGSP-13ACT-B0. Also, SGSP-13ACT-B0 allows manual operation when not electronically controlled, whereas RMH-13 does not allow manual operation.
| RoHS | No |
|---|---|
| CE | No |
| Guide | ▶Please contact our sales for consultation of the optical system using CoreUnit etc. |
| Attention | 1) This set shows an example of a combination of parts and other parts are required for use as a microscope. This product is shipped unassembled, and you are required to assemble the parts and software by yourself. Please contact our sales for details on how to embed them. The specifications of the set are subject to change without notice. 2) Note that the dedicated tool MNS-12.5-14.5 and a ball-point type hexagonal wrench are required to install actuator. 3) Two units of the RMC-102 2-axis dedicated controller can be connected to one PC, and motorized operation of the XY and Z axes can be performed from the PC.. 4) The software provided is a sample program. If you need special control, you will need to develop the program yourself or ask us to custom order it for a fee. 5) The controllable travel range depends on RMH-13SGSP-13ACT-B0 and is therefore up to 13mm. |
